F734/F735 High Capacity Loader Setup - Pitney Bowes F731 Operator's Manual

2 • Operation
F734/F735
High Capacity
Loader Setup
2-14
The F734/F735 High Capacity Loader is an optional unit. If you are not using
the loader, continue with 'Set the DI900/DI950 System' on page 2-16.
Make sure the Loader Control
Sensor t is located onto the F731
Feeder Head.
Press and hold the Manual
Reverse Button until the Pressure
Assembly is far enough to the left.
Open the Front Cover and move
the Material Support Plate to the
left.
Before loading material, you need to ascertain its loading orientation. This
depends on the job settings. The F731 job display will indicate which loading
orientation is required for the job (numbered 1 to 4).
The four possible loading
orientations are illustrated on a
label located behind the F734/F735
Front Cover:
1 Face up, bottom first (as fed
into the F731 feeder)
2 Face up, top first (as fed into
the F731 feeder)
3 Face down, bottom first (as fed
into the F731 feeder)
4 Face down, top first (as fed into
the F731 feeder)
Load material up against the right
hand side of the loader flat against
the Feed Belts.
SDC790A