Pitney Bowes F731 Operator's Manual page 14

1 • Introduction
System
Components
- F731
1-8
1
Top Cover
Provides access to the accumulation area for making adjustments or
clearing stalled material. The cover is interlocked to prevent machine
operation when open.
Feed Deck
2
Equipped with side guides and separator assembly.
Control Panel
3
Operator controls are conveniently grouped on the front of the feeder.
Five multi-function controls govern all programming and paper
handling functions. See page 1-12 for details.
4
Operator Display
The display prompts you through the programming process, shows a
list of available programs and displays error messages.
5 Accumulation Area
Area of the feeder where sheets are collated into sets prior to being
fed into the DI900/DI950 system.
6
Main Power Switch
Applies power to the F731 Universal Feeder.
7
Feeder Head Adjustment Controls (a, b and c)
Adjusts the separator and feed mechanisms so that single items of
material are fed into the accumulation area. Control c adjusts the initial
separation of the material being run. Controls a and b adjust the feed
(take-away) of the single piece of material to the accumulation area.
8
Feeder Side Guides and Control
Used to control the material being fed into the system. Rotate the
control to adjust the guides.
Loader Control Sensor (t)
9
This sensor is only supplied if an F734/F735 High Capacity Loader is
used in the system. It must be fitted onto the F731 Feeder Head (as
shown in the illustration) whenever the F734/F735 is being used. If
the F731 Universal Feeder is being used without the F734/F735, the
sensor must be removed from the Feeder Head and stored in the two
slots in the F731 Rear Cover
SDC790A