How To Physically Connect Your System To The Network Router Port Or Ethernet Wall Outlet - Pitney Bowes DM Series Setup Manual

How to physically connect your system to the Network router port or Ethernet wall outlet

DM100
1. Turn off power to the System.
2. Plug the Ethernet cable into your router or network
wall outlet.
3. Attach the Network Adapter to the Ethernet cable
and then plug the Network Adapter into one of the
USB Ports on the Mailing System using the short
USB cable that comes with the Adapter.
If you are performing an installation on a new machine, please now return to you Installation guide. If you are changing connection method on an existing
machine, please now check that your new connection is working by performing a balance inquiry. If your connection is successful your Account balance will
display. If you experience any issues with connection please proceed to Advanced IT Setup on the next pages. You may need to contact your Network/ IT
Department Administrator.
Pitney Bowes DM Series LAN Connectivity Guide July 2016
Plug into USB port on
Mailing System
USB cable supplied
with network
adapter
Network Adapter
DM300/400
Ethernet cable
Connect to your
router or network
wall outlet.
4. Turn the System power back on.
5. Once the System starts and displays the Mail
Run/Home screen, the LED's on the Network
Adapter should light up or flicker within 15
seconds. This indicates there is a connection
to the network.
AU
Please note- Whether your system has an
on/off switch is dependant on model.
<< Return to Contents