How To Physically Connect Your System To The Network Socket - Pitney Bowes DM Series Setup Manual

How to physically connect your system to the network socket

DM110i/DM160i/DM220i series
Plug into USB port on
Mailing System
USB cable supplied
with network
adapter
1. Turn off power to the System.
2. Plug the Ethernet cable into your router or network
socket.
3. Attach the Network Adapter to the Ethernet cable and
then plug the Network Adapter into one of the USB
Ports on the Mailing System using the short USB cable
that comes with the Adapter.
If you are performing an installation on a new machine, please now return to you Installation guide. If you are changing connection method on an existing
machine, please now check that your new connection is working by performing a balance inquiry. If your connection is successful your Account balance will
display. If you experience any issues with connection please proceed to Advanced IT Setup on the next pages. You may need to contact your Network/ IT
Department Administrator.
SDC876F Pitney Bowes DM Series LAN Connectivity Guide
DM300c/DM400c and
DM300M/DM400M series
Please note- Whether your system has an
on/off switch is dependant on model.
Ethernet cable
Network Adapter
4. Turn the System power back on.
5. Once the System starts and displays the Mail Run/
Home screen, the LED's on the Network Adapter
should light up or flicker within 15 seconds. This
indicates there is a connection to the network.
DM475/DM475M/DM450 series only
Connect to your
router or network
socket
1. Turn off power to the System.
2. Plug the Ethernet cable into your router
or network socket.
3. Plug the other end of the cable into the
LAN socket on the rear of the system.
4. Turn the System power back on.
UK
Plug directly
into system
LAN socket.
Connect to your
router or network
socket
<< Return to Contents