Loading Orientation; Feeder Side Guides Adjustment - Pitney Bowes F731 Operator's Manual

Loading
Orientation
Feeder Side
Guides
Adjustment
SDC790A
The Loading Orientation is shown when you select a program. There are
four possible loading orientations:
1 Face up, bottom first
2 Face up, top first
3 Face down, bottom first
4 Face down, top first
When feeding individual pieces of material during setup, or when loading
material prior to a job run, it is important to observe the correct loading
orientation for the program selected.
Rotate the Feeder Side Guide
adjusting wheel anticlockwise until
the side guides are wider apart
than the material to be run.
Place a sheet or booklet onto the
Feed Deck.
Turn the Feeder Side Guide
adjusting wheel clockwise to close
the side guides up to the sheet or
booklet, then turn it anticlockwise
6 notches allowing an overall
clearance of approximately 3mm
(0.1") between the material and
guides.
Operation • 2
2-5