Feeder Head Adjustment For Cut Sheets And Booklets; Feeder Head Adjustment For Booklets 2.5Mm (3/32") Thick Or Greater; Up To 2.5Mm (3/32") Thick - Pitney Bowes F731 Operator's Manual

Feeder Head
Adjustment for
cut sheets and
booklets up to
2.5mm (3/32")
thick
Feeder Head
Adjustment for
booklets 2.5mm
(3/32") thick or
greater
SDC790A
Open the Top Cover.
Turn knob c anticlockwise until it
stops.
Unlock lever a and, with no
material in the feeder, let the
Feeder Head come to rest.
Turn knob b anticlockwise as far as it will go, hold knob b in place and lock
lever a.
Close all covers and press the Run Confirm (Green) button to make the
feeder motor run.
Take two pieces of the material to be run and feed them, by hand, into the
separator. If both pieces feed completely under the separator, pull them out
and tighten knob c clockwise slightly.
Repeat the previous step until only one piece feeds completely and the
second piece is held back.
Open the F731 Top Cover.
Turn knob c anticlockwise until it stops.
Unlock lever a, then turn knob b clockwise all the way and hold.
Place a booklet all the way under the first and second rollers.
Release knob b so that the Feeder Head rests on the booklet.
Rotate knob b anticlockwise 8 divisions on the scale and hold in this
position whilst locking lever a.
Try to slide a second booklet under the separator. If it goes under, pull it
back and turn knob c clockwise enough that a second booklet cannot slide
under the separator.
Close the cover.
Operation • 2
2-11