Pitney Bowes F731 Operator's Manual page 56

4 • Troubleshooting & Maintenance
4-6
Problem
Material stops
in the F731
accumulation area.
Display prompts
'Double feed error'.
Material stops in
the separation
area. Display
prompts 'Double
feed error'.
Multiple feed
errors or stream
feed errors.
Feeder display
indicates 'DF
Sensor Out of
Limit'.
Feeder display
indicates
'Current Job Not
Compatible'.
Feeder display
indicates 'No
Material for Double
Feed Adjustment'.
Feeder display
indicates 'Wrong
Accumulation
Direction'.
Possible Cause
Check the Accumulator Side Guide settings (see
page 2-12) and the Ramp settings (see page 2-13).
Wrong program selected from listing.
The F731 has detected a 'Double Feed'. Push the
Stop/Clear Deck button to advance the material
into the accumulator area for error correction. If
double feeds persist, refer to the Feeder Head
adjustment on page 2-11.
Check the Feeder Head adjustment
(see page 2-11).
The material is too thick to be sensed by the double
detection system.
Check that you have selected the correct program
(see page 2-4).
Check that the job is programmed correctly i.e.
'Paper' or 'Booklet' (if appropriate) selected in
material selection to turn double detect off (see
pages 3-2, 3-5 or 3-11).
Check the job setups on the F731 Universal Feeder
AND the material listed for feeder Y on the DI900/
DI950 Inserter to ensure that both have the same
material type and loading orientation.
If scanning is being used, check it is selected in
both the F731 AND the DI900/DI950 programs.
Take a single sheet and load it onto the F731 Feed
Deck (see page 2-5).
Material not being transported to Take-Away Roller.
Adjust Feeder Head settings (see page 2-11).
Check the position of the Accumulator Ramp (see
page 2-2).
SDC790A