Adding A Scanning Program; Programming An 'Omr Di900/Di950' Job - Pitney Bowes F731 Operator's Manual

Adding a
Scanning
Program
Programming
an 'OMR DI900/
DI950 Job
SDC790A
Background information on scanning is given in the DI900/DI950 Operating
Guide. This section assumes you understand scanning and how it applies
to the job you are programming. It also assumes you are familiar with
programming non-scanning jobs as described on page 3-2.
NOTE: If you select booklets, no scanning is available.
The following sections give two examples of setting up scanning jobs. One
for OMR scanning and one for BCR scanning.
HINT: We advise you keep a 'hard copy' of all your programmed jobs for
your own future reference.
When you program the feeder for an OMR scanning job, you enter the
program in a similar way as a non-scanning job, then...
• Specify the scan line increments
• Select the scan functions you wish to use
• Specify the distance from the lead edge to the bench mark
• Specify where each scan line is in relation to the first line
Step by Step Instructions
With the feeder ON, press the Green, Blue and Red buttons at the same
time. The display shows the program type selection:
Select: NEW NON-SCANNING JOB
<-->=SELECT
Press the Arrow Buttons to select 'NEW SCANNING JOB'.
Select: NEW SCANNING JOB
<-->=SELECT
Press Green to enter the scanning programming mode.
The display shows the program naming screen:
Green=Confirm
Green=Confirm
Programming • 3
Blue=EXIT
Blue=EXIT
3-5