Attach Elbow Assembly To Flange Assembly - KidKraft CASTLEWOOD Installation And Operating Instructions Manual

Step 32: Attach Elbow Assembly to Flange Assembly
Part 1
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the
round recess and the lock nuts go through the side with the hexagonal recess. Keep all bolts loose
until further step.
A: Fit one of the Elbow Assemblies to the Flange Assembly by lining up the arrows on each assembly. (fig.
32.2 and 32.3)
B: Attach 1 TNR2 Slide Clamp Ring to the top of the joined Assemblies using 3 (PB1) Pan Bolts (with lock
nut), making sure to match the arrows up with the end of the clamp ring (where a seam will be) as shown in fig.
32.2 and 32.3.
Use Quadrex Driver as a guide pin for each hole before inserting bolt. (fig. 32.3)
Fig. 32.1
DO NOT USE
USE IMAGE
LN1
Fig. 32.4
Do not install bolt
in Clamp Ring ends
until Step 32D
Fig. 32.2
Flange
Assembly
Top Slide Bolt Holes
3 x
PB1
LN1
PB1
Hardware
Pan Bolt (lock nut)
68
Quadrex Driver
Use special driver provided
in locations where the curve
of the elbow are difficult to
reach with a standard driver.
Fig. 32.3
Align each elbow using the
molded arrows with the seam
of the clamp ring.
Elbow
Assembly
Other Parts
1 x Quadrex Driver
1 x TNR2 Slide Clamp Ring