Attach Elbow Assembly To Flange Assembly - KidKraft Cedar Summit Lookout Extreme Installation And Operating Instructions Manual

Step 71: Attach Elbow Assembly to Flange Assembly
Note: Keep all bolts loose until further step.
A: Fit one of the Elbow Assemblies to the Flange Assembly by lining up the arrows on each assembly. Attach
Elbow Assembly to Flange Assembly using 6 ¼ x 12.7mm" Pan Bolts and Square Lock Nut. (Fig. 71.2 & 71.3).
B: Attach one of the Elbow assemblies to another Elbow Assembly making sure to line up the arrows on each
assembly. Attach using 6 ¼ x 12.7mm Pan Bolts with Square Lock Nut. Repeat this instruction to make 2 more.
(Fig. 71.2 & 71.3)
Use Quadrex Driver as a guide pin for each hole before inserting bolt.
Fig. 71.1
Fig. 71.3
Align each elbow using the
molded arrows.
Fig. 71.2
Top Slide Bolt Holes
Square
Lock Nut
Elbow
Assembly
125
Quadrex Driver
Use special driver provided
in locations where the curve
of the elbow are difficult to
reach with a standard driver.
¼ x 12.7mm
Pan Bolt
Flange
Assembly
Other Parts
1 x Quadrex Driver
24 x 1/4 x 12.7mm Pan Bolt
24 x 1/4" Square Lock Nut