Attach Elbow Assembly To Flange Assembly - KidKraft COZY ESCAPE PLAYHOUSE F29045 Installation And Operating Instructions Manual

Step 35: Attach Elbow Assembly to Flange Assembly
Note: Keep all bolts loose until further step.
A: Fit one of the Elbow Assemblies to the Flange Assembly by lining up the arrows on each assembly. Attach
Elbow Assembly to Flange Assembly using 6 (PB1) ¼ x 3/4" Pan Bolts and Square Lock Nut. (fig. 35.1, 35.2 and
35.3)
B: Attach one of the Elbow assemblies to another Elbow Assembly making sure to line up the arrows on each
assembly. Attach 6 (¼ x 12.7)mm Pan Bolt with Square Lock Nut. Repeat this instruction for 2 more. (fig. 35.2
and 35.3)
Use Quadrex Driver as a guide pin for each hole before inserting bolt.
Fig. 35.1
Fig. 35.3
Align each elbow using the
molded arrows.
Fig. 35.2
Top Slide Bolt Holes
Square
Lock Nut
Use a 7/16" open end
wrench for nuts
70
Quadrex Driver
Use special driver provided
in locations where the curve
of the elbow are difficult to
reach with a standard driver.
Elbow
Assembly
1 x Quadrex Driver
24 x 1/4 x 12.7mm Pan Bolt
24 x 1/4" Square Lock Nut
¼ x 12.7mm
Pan Bolt
Flange
Assembly
Other Parts