Hysteresis Limit Value - ProMinent DULCOMETER Assembly And Operating Instructions Manual

10.4

Hysteresis limit value

Measured value
Upper
limit value
"Hysteresis"
"Hysteresis"
Lower
limit value
Limit value
transgression
Fig. 38: Hysteresis
Upper limit value =
Lower limit value =
The range between
The controller has a
An error message is emitted if, for example,
the level falls below 0.95*
[LIMIT↓] , the error message is issued, which is retracted again after exceeding 1.05*
[LIMIT↓] .
[LIMIT↑]
[LIMIT↓]
[LIMIT↑] and [LIMIT↓] is the valid measuring range.
[hysteresis] , which is set as a % to the respective [LIMIT] value.
[LIMIT↑] , the error message is retracted. If the level calls below
Control parameters and functions
[HYST] = 5 % and [LIMIT↑] is exceeded. If
t
t
A0009_GB
91