Terminal Diagram / Wiring - ProMinent DULCOMETER Assembly And Operating Instructions Manual

Assembly and installation
5.4.3

Terminal diagram / wiring

1.
3.
Fig. 11: Terminal diagram label for the Compact Controller
1. Control signal = Control signal to the
transmission coil.
2. Measuring signal = Measuring signal
from the receiver coil.
3. Cable shield connector to pin 2 of ter‐
minal XE2 as optional connection for
outer cable shield when using ICT 2,
ICT 5 or CLS 52 sensors.
X1 Transmission coil connector
X2 Receiver coil connector
Please refer to the connector overviews on the following pages:
Ä Tab. 4 'Assignment of terminals to the respective sensors' on page 34
–
Ä Tab. 5 'Recommended cable diameter' on page 35
–
Ä Tab. 6 'Threaded connectors of cable openings' on page 36
–
Ä 'Terminal diagram' on page 38
–
And also the chapter Ä Chapter 6 'Sensor connector' on page 42
–
And also the chapter Ä Chapter 7.3 'Selecting the sensor type ' on page 46
–
32
2.
A1859