Stop/Start] Key - ProMinent DULCOMETER Assembly And Operating Instructions Manual

[STOP/START] key

10.2
Control is started / stopped by pressing
menu currently displayed. However the [STOP] state is only shown in the contin‐
uous display.
Fig. 36: key
When the controller is first switched on, it is in
In the event of defined error conditions, the controller switches to
trol is then off (= 0 % control variable).
To differentiate the operating status
[STOP] , caused by pressing
status
Pressing therefore causes the operating status
Pressing once more causes the controller to start up again.
[STOP] status, start the controller manually by pressing
In
Controller [STOP] means:
Control is stopped
n
The P-relay functioning as a limit value relay and as a PWM relay are switched to a
n
de-energised state
The P-relay acting as an alarm relay is activated (no alarm)
n
The controller restarting causes the following:
[STOP] status existed, then you have to manually start the controller after
If a
n
switching on again.
Error detection starts afresh, all existing errors are erased
n
Control parameters and functions
. You can press
[STOP] mode.
[STOP] , caused by an error, from the operating
[ERROR STOP] is displayed instead of [STOP] .
,
[ERROR STOP] to become [STOP] .
regardless of the
STOP
[STOP] mode. The con‐
.
A1872
89