ProMinent DULCOMETER Assembly And Operating Instructions Manual page 25

Compact controller measurement: inductive conductivity
Table of Contents

Advertisement

Fitting the DULCOMETER
NOTICE!
Ribbon cable base
The base for the ribbon cable is firmly soldered onto the PCB. The base cannot
be removed. Open the base lock (3) to loosen the ribbon cable, see Fig. 6
Fig. 6: Loosening the ribbon cable
1.
Loosen four screws and open the DULCOMETER
2.
Open the right and left lock (3) (arrows) on the base and pull the ribbon cable (1)
out of the base
3.
Use pliers to break off the catches (2 and 4). These are not needed for control
panel installation
Compact Controller into the cut-out in the control panel
®
1.
Assembly and installation
2.
4.
Compact Controller
®
3.
25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents