ProMinent DULCOMETER Assembly And Operating Instructions Manual page 74

Operating menus
Setting
Display Starting
value
[↳
77.0 °F
VALUE]
[CON‐ [pause]
TACT]
[↳ POL] [norm.open] [norm.open]
[↳ DELAY
0 s
OFF]
[↳ [off]
ALARM]
[FILTER] : The default value of 3 seconds is suitable in most cases. You should only
1)
increase the default value of 3 seconds with fluctuating readings, a factor that also
increases the setting time of the display value.
Sensor
Selection of the sensor connected
If the connected sensor is changed, all the sensor-dependent settings are reset to
their [DEFAULT] values.
Temperature sensor
[auto]: with conductivity sensors with integral temperature sensor
–
[Manual], 25 °C: with conductivity sensors without integral temperature sensor
–
The electrolytic conductivity of the liquid predominantly depends on the ion concentration.
The geometrical conditions of the sensor surroundings and the geometry of the sensor
itself have to be taken into consideration with the measurement.
74
Possible values
Increment Lower
value
0.1 32.0 °F
[pause]
[ hold]
[norm.closed]
1 0 s
[on]
[off]
Upper Remark
value
302.0 °F Manual correction
value °F
Configuration of digital
contact input
Polarity of the contact
input
3600 s Switch-off delay of
contact input
Alarm at
[PAUSE] event
[Hold] or