Priming [Prime] - ProMinent DULCOMETER Assembly And Operating Instructions Manual

Control parameters and functions
10.3 Priming
Fig. 37: Priming, e.g. to vent a pump
While the continuous display is visible, in
start the priming function
Depending on the configuration of the controller, the output relay
100 %, the frequency relay
output at the mA output. However this is only the case if these outputs are set as
actuators.
[P-REL] starts after priming in an activated state.
The output relay
You can use this function, for example, to transport the feed chemical up to the pump to
bleed the metering line.
90
[PRIME]
STOP
[PRIME] by simultaneously pressing
[f-REL] is actuated at 80 % of "PUMPMAX" and 16 mA is
[STOP] and [OPERATION] modes, you can
PRIME↑↑↑
and .
[P-REL] is actuated at
[dosing]
A1873