Teach In - Siemens SINUMERIK 808D Programming And Operating Manual

4.2

Teach In

Functionality
Using this function, an approached axis position can be directly entered into a specific
traversing block.
Operating sequences
1. You can reach the "Teach In" function in the machining step program by pressing the
Manual Machine Plus (Turning)
Programming and Operating Manual, 12/2012, 6FC5398-3DP10-0BA0
"Teach In" softkey.
Figure 4-8 Selecting the "Teach In" function
The controller switches to the manual machining screen forms of axis-parallel turning,
taper turning and radius turning.
Figure 4-9 Executing "Teach In" - axis-parallel roughing machining mode
Machining the machining step program manually
4.2 Teach In
93