Table of Contents
Advertisement
System Configuration and Menu Options
Root Menu Items
The Mode key accesses the three primary modes of the Q9 Plus ASD: the Frequency Command mode,
the Monitor mode, and the Program mode. From any mode, press the Mode key to loop through to the
other two modes (see
reaching the Frequency Command mode.
The Alarm or Fault information will be displayed in the event of an active Alarm or Fault. Alarm text
will be displayed on the Frequency Command screen when active. Fault information will be displayed
via a Fault screen. See
Figure 28. Q9 Plus ASD Root Menu Navigation.
Frequency Command Mode
Frequency Setting
While operating in the Hand mode (Hand LED is illuminated), the running frequency of the motor may
be set from the Frequency Command screen. Using the Rotary Encoder, enter the Frequency
Command value, connect ST to CC, provide a Run command (F and/or R), and then press the Run key.
The motor will run at the Frequency Command speed and may be changed while running. See
(Hand) on pg. 34
Q9 Plus ASD Installation and Operation Manual
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Figure
28). Press the ESC key from any mode to return to the previous mode until
Alarms, Trips, and Troubleshooting on pg. 245
for more information on the Frequency Command mode.
for more information.
Operation
41
Advertisement
Table of Contents
