Toshiba VLP Technology Q9 Plus Installation & Operation Manual page 180

F505
Acceleration/Deceleration Switching Frequency 1
Program Special  ACC/DEC Special
This parameter sets the frequency at which the acceleration control is switched
from the Accel 1 profile to the Accel 2 profile during a multiple-acceleration
profile configuration.
IP Address Setting Method
Program Communications Ethernet Settings
This parameter is used to select the method used to set the IP address for a
network device (ASD).
Selecting Manual at this parameter will require that parameters
and parameters F582 – F584
Subnet Mask Data, respectively, for the device.
Selecting BOOTP or DHCP results in the IP address being supplied by the
server. See F577 for additional information on setting the IP address.
Settings:
0 — Manual
1 — BOOTP
2 — DHCP
IP Card Data 1
Program Communications Ethernet Settings
Selecting Manual at parameter
used to create an IP address for the connected device.
This parameter is used to configure the IP Data Card 1 section of the IP
address of the device.
IP Card Data 1 IP Card Data 2 IP Card Data 3
IP Card Data 2
Program Communications Ethernet Settings
This parameter operates in conjunction with parameter F577.
This parameter is used to configure the IP Data Card 2 section of the IP
address of the device.
See F577 for additional information on this parameter.
IP Card Data 3
Program Communications Ethernet Settings
This parameter operates in conjunction with parameter F577.
This parameter is used to configure the IP Data Card 3 section of the IP
address of the device.
See F577 for additional information on this parameter.
Q9 Plus ASD Installation and Operation Manual
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
be used to manually create the IP address and
F576 enables parameters F577
IP Card Data 4
Direct Access Number — F505
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq. (F011)
Units — Hz
Direct Access Number — F576
Parameter Type — Selection List
Factory Default — Manual
Changeable During Run — Yes
F577 – F580
Direct Access Number — F577
Parameter Type — Numerical
– F580 to be Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
Direct Access Number — F578
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
Direct Access Number — F579
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 255
F579
171