Table of Contents
Advertisement
F660
Adding Input Selection
Program Feedback Override Control
This parameter Enables/Disables the feature that allows for the external
adjustment of the Output Frequency.
Selecting either of the input methods listed enables this feature. The selected
input is used as a modifier of the programmed Output Frequency.
Settings:
0 — Disabled
1 — V/I
2 — RR
3 — RX
4 — Panel Keypad
5 — RS485 2-Wire (EOI)
6 — RS485 4-Wire (Terminal Board)
7 — Communication Option Board
8 — RX2
9 — Option V/I
10 — UP/DOWN Frequency
11 — Optional RP Pulse Input
12 — Optional High-Speed Pulse Input
13 — Binary/BCD (Option)
Multiplying Input Selection
Program Feedback Override Control
This parameter Enables/Disables the feature that allows for the external
adjustment of the commanded frequency.
Selecting either of the input methods listed enables this feature. The selected
input is used as a multiplier of the commanded frequency.
If Setting (F729) is selected, the % value entered at parameter F729 is used as
the multiplier of the commanded frequency. Contact the TIC Customer
Support Center for more information on using this selection.
Settings:
0 — Disabled
1 — V/I
2 — RR
3 — RX
4 — Setting (F729)
5 — RX2 Option
Logic Output/Pulse Output (OUT1) (not used)
Program Terminal Analog Output Terminals
This parameter is used to select the output of the OUT1 terminals.
Settings:
0 — Logic Output
1 — Pulse Train Output
186
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Direct Access Number — F660
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — Yes
Direct Access Number — F661
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — Yes
Direct Access Number — F662
Parameter Type — Selection List
Factory Default — Logic Output
Changeable During Run — No
Q9 Plus ASD Installation and Operation Manual
F662
Advertisement
Table of Contents
