System Configuration And Menu Options; Root Menus - Toshiba G7 Quick Start Manual

System Configuration and Menu Options

Root Menus

The MON/PRG key accesses the three primary modes of the G7: the Frequency Command mode, the
Monitor mode, and the Program mode. From either mode, press the MON/PRG key to loop through
to the other two modes (see
key toggles the menu to and from the Panel menu and the Frequency Command mode.
Note: Panel menu changes made when accessing the Panel menu using the method shown
in Figure 18
Figure 18. Root menu mapping.
Frequency Command Mode
Frequency Setting
While operating in the Local mode (Local LED is illuminated on the front panel), the running
frequency of the motor may be set from the Frequency Command screen. Using the Rotary Encoder,
enter the Frequency Command value and then press the Run key. The motor will run at the
Frequency Command speed and may be changed while running.
Scrolling Monitor
The Output Current and the ASD Load values are displayed (default setting) below the Frequency
Command parameter of the Frequency Command screen. Other user-selected parameters may be
displayed on this screen for quick-access monitoring while running. These parameters may be accessed
and enabled for display by placing a check in the box next to the item listed at Program ⇒ Monitor
Setup ⇒
Scrolling Monitor
When more than two items are selected for display the items are scrolled automatically. The display
time for each selected item may be set from 1 to 60 seconds. The parameters that may be displayed on
the Scrolling Monitor are listed in the section titled
G7 ASD Quick Start Guide
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Figure 18). While in the Frequency Command mode, pressing the ESC
is effective for Local LCD EOI control Only.
Select. If no parameters are enabled for display, No Items is displayed.
Monitor Mode on pg. 46.
27