Table of Contents
Advertisement
Remote Mounting without the Mounting Kit
Note:
See
Figure 27
1.
At the EOI mounting location, mark the 3.80" by 3.56" hole and the four 7/32" screw holes.
2.
Cut the 3.80" by 3.56" rectangular mounting hole.
3.
Drill the four 7/32" screw holes.
4.
Remove the Front Panel Assembly of the ASD — using a flathead screwdriver, release the upper
retaining tabs of the EOI panel. Then pivot the EOI assembly away from the ASD and lift (see
26).
5.
Remove the EOI from the Front Panel Assembly of step 4 — discard the assembly.
6.
Attach and secure the EOI to the front side of the mounting location using the four 6-32 x 5/16" pan
head screws, the #6 split lock washers, and the #6 flat washers.
7.
Install the Front Panel Connector Assembly to the ASD (see
8.
Connect the Extender Cable from the EOI to the Front Panel Assembly.
Figure 27. EOI Remote Mounting Dimensions (inches/millimeters).
Q9 Plus ASD Installation and Operation Manual
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
for the dimensions and the item locations referenced in steps 1 – 7.
Figure
26).
Figure
33
Advertisement
Table of Contents
