Table of Contents
Advertisement
DBR OL (Overload) Trip (not used)— Displays the DBR Overload Trip value as a percentage
of the Dynamic Braking Resistor capacity.
DBR Load (not used)— Displays the DBR Load as a percentage of the Dynamic Braking
Resistor capacity.
Feedback (Inst) — Provides a status of the Real-Time Feedback in Hz.
Feedback (1 Second) — Provides a status of the 1-Second Averaging feedback in Hz.
Torque — Displays the Output Torque as a percentage of the rated capacity of the Q9 Plus ASD.
Torque Reference — Displays the Torque Reference as a percentage of the maximum torque
available.
Torque Current — Displays the torque-producing current value.
Exciting Current — Displays the current value required to produce the excitation field.
PID Feedback — Provides a status of the PID Real Time Feedback in Hz.
Input Power — Displays the Input Power in Kilowatts (kW).
Output Power — Displays the Output Power in Kilowatts (kW).
Pattern Group # — Displays the active Pattern Run Group Number.
Pattern Cycle # — Displays the cycle number of the active Pattern Run Group.
Pattern Preset # — Displays the active Preset Speed of the active Pattern Run Group being run.
Pattern Time — Displays the remaining time for the active Pattern Run Group.
RR Input — Displays the RR input value as a percentage of the full range of the RR value
(potentiometer input).
*V/I Input — Displays the V/I input setting as a percentage of the full range of the V/I value.
Note: The isolated V/I input terminal may receive Current or Voltage to control the output
speed or the output torque. The input signal type must be selected at SW301 on the
Terminal Board.
The V input setting of SW301 is used for the 0 – 10 VDC analog input signal and the
I input setting of SW301 is used for the 0 – 20 mA analog input signal. Either may be
used as a frequency or torque control source. Throughout this manual, they will be
selection-specific and may be listed as V/I.
See parameter
RX Input — Displays the RX input setting as a percentage of the full range of the RX value (-10 to
+10 VDC Input).
RX2 Input — Displays the RX2 input setting as a percentage of the full range of the RX2 value.
Note:
The RX2 terminal function is available on the Expansion IO Card Option 1 Option
Board (P/N ETB003Z) only.
Trip Code — Displays None if there are no errors, or displays one of the associated Fault Codes
listed in
Table 19 on page 251
Past Trip 1 — This function records and displays the last trip incurred. Subsequent trips will replace
Past Trip 1. As trip records are replaced, they are shifted to the next level of the Past Trip locations
until being deleted (i.e., Past Trip 1 is moved to Past Trip 2 and then to Past Trip 3 until being
shifted out of Past Trip 4). Once shifted out of Past Trip 4, the record is deleted. If no trips have
occurred since the last reset, No Error is displayed for each trip record.
44
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
F201
for more information on the setup of this input.
if there is an active Fault (e.g., E = Emergency Off).
Q9 Plus ASD Installation and Operation Manual
Advertisement
Table of Contents
