Table of Contents
Advertisement
Figure 33. Complete the Virtual Linear Pump Setup.
16. Press the Stop key to complete
the setup.
17. Click Exit to save settings
(Exit becomes available at
zero Hz).
Figure 34. Run the Motor/Pump in the Direct Mode.
18. Press the ESC key until reaching
the Frequency Command
screen.
19. From the Frequency Command
screen, press ESC and scroll to
the Control field. Select Direct
Mode if using no feedback (if
using feedback, go to
pg.
75).
20. While in the Hand mode, press
Run.
21. While running, adjust parameters
F500
operation if unstable.
74
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Step 22. on
and
F501
to stabilize
Press ESC
Q9 Plus ASD Installation and Operation Manual
Advertisement
Table of Contents
