Table of Contents
Advertisement
F130
UT1
Output Terminal 1 (OUT1) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT1 discrete output
terminals O1A and O1B.
The O1A and O1B (OUT1) output terminals change states (open or close) as a
function of a user-selected event. See
possible assignments for the OUT1 terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
UT2
Output Terminal 2 (OUT2) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT2 discrete output
terminals O2A and O2B.
The O2A and O2B (OUT2) output terminals change states (open or close) as a
function of a user-selected event. See
possible assignments for the OUT2 terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
Output Terminal 3 (FL) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the FL output terminals to one
of the user-selectable functions listed in
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
Output Terminal 4 (OUT3) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT3 discrete output
terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable OUT3 terminal to one of
the user-selectable functions listed in
Note:
The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N 58685) for
additional information on the function of this terminal.
Q9 Plus ASD Installation and Operation Manual
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Table 13 on pg. 239
for a listing of the
Table 13 on pg. 239
for a listing of the
Table 13 on pg.
239.
Table 13 on pg.
239.
Direct Access Number — F130
Parameter Type — Selection List
Factory Default — Damper Command
Changeable During Run — No
Direct Access Number — F131
Parameter Type — Selection List
Factory Default — Acceleration/
Deceleration Completion
Changeable During Run — No
Direct Access Number — F132
Parameter Type — Selection List
Factory Default — Failure FL (All
Trips)
Changeable During Run — No
Direct Access Number — F133
Parameter Type — Selection List
Factory Default — Always OFF
Changeable During Run — No
F133
99
Advertisement
Table of Contents
