AudioCodes Mediant 800 User Manual page 111

CHAPTER 8 SNMP-Based Management
2. Configure a rule according to the parameters described in the table below.
3. Click Apply, and then reset the device with a save-to-flash for your settings to take effect.
Table 8-4: Alarms Customization Parameter Descriptions
Index
[AlarmSeverity_Index]
Name
name
[AlarmSeverity_Name]
Original Severity
alarm-original-severity
[AlarmSeverity_OriginalSeverity]
Parameter
- 71 -
Mediant 800 Gateway & E-SBC | User's Manual
Description
Defines an index number for the new
table row.
Note: Each row must be configured
with a unique index.
Defines the SNMP alarm that you
want to customize.
Note: The CLI and ini file use the last
digits of the alarm's OID as the name.
For example, configure the parameter
to "12" for the
acActiveAlarmTableOverflow alarm
(OID is
1.3.6.1.4.15003.9.10.1.21.2.0.12).
For alarm OIDs, refer to the SNMP
Reference Guide for Gateways-
SBCs-MSBRs.
Defines the original severity level of
the alarm, according to the MIB.
■ [0] Default = (Default) All
supported severity levels of the
alarm. If you select this option, the
alarm and its' severity depends on
the 'Original Severity' parameter:
✔
If configured to Suppressed,
the device doesn't send the
alarm at all.