RSTP Configuration Example
1. Configure port and VLAN membership on the switch.
2. Set the Spanning Tree mode to Rapid Spanning Tree.
3. Configure RSTP parameters.
4. Configure port parameters:
166
CN4093 Application Guide for N/OS 8.3
This section provides steps to configure RSTP.
CN 4093(config)# spanning-tree mode rstp
CN 4093(config)# spanning-tree stp 1 bridge priority 8192
CN 4093(config)# spanning-tree stp 1 bridge hello-time 5
CN 4093(config)# spanning-tree stp 1 bridge forward-delay 20
CN 4093(config)# spanning-tree stp 1 bridge maximum-age 30
CN 4093(config)# no spanning-tree stp 1 enable
CN 4093(config)# interface port 3
CN 4093(config-if)# spanning-tree stp 1 priority 240
CN 4093(config-if)# spanning-tree stp 1 path-cost 500
CN 4093(config-if)# no spanning-tree stp 1 enable
CN 4093(config-if)# exit