Power Steering and Vacuum Pump
Page 5-6
Service Brakes
DODGE Turbo Diesel
Clean parts in hot water and detergent or use a solvent and
blow dry with compressed air.
Reassembly
Install the two spacers on the studs on the power steering
pump.
Install the gear/eccentric/bearing assembly by pulling it onto
the power steering shaft with a 3/8 inch 18 thread capscrew
with a flat washer threaded into the power steering pump shaft.
Pull it on until it bottoms.
Caution: This is a press fit and will require a minimum of
SAE Grade 8 capscrew for thread strength.
Remove capscrew and washer after pulling eccentric on to the
shaft.