Table of Contents
Advertisement
Base Engine Components
DODGETurbo Diesel
Out-of-Chassis Repairs
Page 91-15
Note: Vertical strikes must be smooth continuous
along the full length of the bore.
Inspect the bore after 10 strokes.
Use a strong solution of hot water and laundry detergent to
L\
clean the bores.
Since a large volume of water must be used to rinse the bores,
position the block over or close to a floor drain.
Caution: Clean the cylinder bores Immediately after d e -
glazlng.
Rinse the bores until the detergent is removed and blow the
block dry with compressed air.
Caution: Be sure to remove the tape covering the lube
holes after the cleaning process is complete.
Check the bore cleanliness by wiping with a white, lint free,
lightly oiled cloth. If grit residue is still present, repeat the
cleaning process until all residue is removed. Wash the bores
and the complete block assembly with solvent and dry with
compressed air.
Advertisement
Table of Contents
Troubleshooting
