Dodge D250 1990 Service Manual page 262

Base Engine Components
DODGE Turbo Diesel
In-Chassis Repairs
Page 9F-33
Use the alignment/installation tool from the seal kit to align the
cover to the crankshaft.
10mm
Tighten the gear cover capscrews.
Torque Value: 24 N.m [18 ft-lbs]
Remove the alignment/installation tool.
Caution; Always use a seal pilot when you install a seal.
Apply a bead of Loctite 277 to the outside diameter of the seal. (0®t
Install the pilot from the seal kit onto the crankshaft.. Install the
seal onto the pilot and start into the front cover. Remove the
pilot.
Alignment/Installation Tool, Plastic Hammer
Note: To prevent damage to the seal carrier, hit the
wMjt
alignment/installation tool alternately at the 12, 3, 6 and 9
o'clock positions.
Use the alignment/installation tool and a plastic hammer to
install the seal to the correct depth.