Fuel System Replacement Procedures
Page 14-18
Fuel System
DODGE Turbo Diesel
10mm
Bleed the air from the system.
Operate the hand lever until the fuel flowing from the fitting is
free of air. Tighten the bleed screw.
Torque Value: 8 N-m [6 ft-lbs].
Note: If the lever feels as though it is not pumping, rotate the
engine appoximately 90 degrees and proceed.
Caution: The hand priming lever must be returned to the
lock position after priming. The lever will be In the up
position when locked.
14mm and 17mm
Lift Pump - Replacement
:*) Disconnect the low pressure fuel lines.
10mm
Remove the two capscrews and lift pump from the cylinder
block. Clean the mounting surface to remove any gasket.