Table of Contents
Advertisement
Fuel System
DODGE Turbo Diesel
Throttle Linkage Adjustments
Page 14-39
3. Observe that the throttle lever of the distributor pump is
making contact with the low idle stop screw. Also that the
spring load breakover lever has moved off the stop and is
against the breakover spring.
4. If the low idle stop screw and the breakover spring is not
contacted, then the throttle actuation rod must be
adjusted.
10mm
5. Hold the actuation rod flat and loosen the locking nuts.
Note: One nut is a left hand thread/L" marked on the flat
will indicate the side of the rod with this nut.
Advertisement
Table of Contents
Troubleshooting
