New Engine Break-In; Starting The Engine; First Start Up Of The Day - Dodge D250 1990 Service Manual

1
Lubrication and Maintenance
DODGE Turbo Diesel
4. After engine is started or if engine fails to start, cables must
be disconnected in the following order:
a. Disconnect the negative cable at engine ground.
b. Disconnect the negative cable at negative post on
booster tottery.
c. Disconnect cable between positive post of both
batteries.
Warning: Any procedure other than above could result
in: 1) Personal injury caused by electrolyte squirting out
the battery vent, 2) Personal Injury or property damage
due to battery explosion, 3) damage to charging system
of booster vehicle or of Immobilized vehicle.
Operating Instructions
Page OB-5
With Portable Starting Unit
There are many types of these units available. Follow
instructions of their manufacturer for necessary precautions
and operation.
Caution: However, it Is very important that their operating
voltage does not exceed 12 Volts D.C. because damage • •
to battery, starter 'motor, alternator or electrical system
may occur.
New Engine Break-in
The care given the engine during the 1000 miles of operation can result in longer life, better performance and more
economical operation. During this period, follow these recommendations If it is practical to do so:
• Warm up the engine before placing It under load.
• Do not operate the engine at Idle or full load for more than 5 minutes.
• Avoid constant speeds.
- Use the appropriate transmission gear to prevent engine lugging.
• Observe vehicle oil pressure and temperature indicators.
• Check the coolant and oil levels frequently.
Starting the Engine
First Start Up of the Day - If this Is the first start of the day, perform your daily maintenance checks:
- Oil Level - See Page 0C-4.
- Coolant Level - See Page 0C-4.
• If the Water in Fuel light is on, drain water from Fuei\Water Separator Filter - See Page OC-5.
- Visually check the engine and components - See Page 0C-4, OC-5.