Fuel System Replacement Procedures - Dodge D250 1990 Service Manual

Fuel System Replacement Procedures
Page 14-28
Fuel System
DODGE Turbo Diesel
10mm, 13mm
:») Remove the pump support bracket.
17mm
:») Remove the oil fill tube bracket capscrew. Remove the fill tube
and adapter from the front gear cover.
22mm
Caution: Be careful when removing the gear retainer nut
and washer. If the nut or washer drop Into the front gear
housing, the front gear cover must be removed to
retrieve them.
Place a shop towel In the gear cover opening between the gear
and cover. This will prevent the nut or washer from falling into
the gear housing. Remove the gear retaining nut and washer.
Barring the engine
Barring Tool
The barring tool is inserted into the flywheel housing opening
on the exhaust side of the engine. Place a 1/2 drive universal
joint in the barring tool. Put enough 1/2 inch drive extensions
together to equal at least 36 inches. Place the extension under
the turbocharger to the barring tool as shown. Use a ratchet to
turn the barring tool.