Base Engine Components
DODGETurbo Diesei
Out-of-Chassis Repairs
Page 91-29
8mm
Align the seal housing to the crankshaft with the alignment tod
provided in the seal kit. Make sure the seal housing is level with
^
both sides of the block oil pan rail. Tighten the capscrews.
Torque Value: 9 N-m [7 ft-lbs]
Remove the alignment tool and trim the gasket even with the oil
pan mounting surface.
Rear Crankshaft - Installation
Seal O.D. Lubrication/Sealant
• Rubber O.D. rear crankshaft seals are lubricated with
soapy water.
• Seals without rubber O.D. use Loctite 277, 11264 or No.
2654422 Sealant.
Install the seal pilot, provided in the replacement kit, onto the
crankshaft. Push the seal onto the crankshaft.