Introduction
Page 6
CHRYSLER MOTORS
DODGE Turbo Diesel
Definition of Terms
The following is a list of guidelines for each procedure in the "Repair Sections" of the Troubleshooting and Repair
Manual, The procedure will be given first; followed by a definition of the step or steps involved.
- Check - Examine a component or system for damage, excessive wear, accuracy, safety, or performance.
• Inspect - Examine a component or dimension to make sure it meets the required specifications.
• Test - Check or compare the performance of a component or system to established specifications.
- Adjust - Complete the necessary steps to set or adjust the component, assemblies, or system in the required
setting or position.
• Visually Inspect - Look for any obvious damage or problem.
• Remove-Take off a component or assembly.
• Clean - Remove dirt, grease or other contamination.
« Disassemble - Take the component or assembly apart.
• Repair - Restore a component or assembly to a serviceable condition within the established specifications.
NOTE: Only the easiest and simplest repairs will be made to a component or assembly. If a component or assembly
must be rebuilt, it must be replaced with a new or reconditioned component or assembly.
• Replace - Install a new, properly rebuilt reconditioned component or assembly in place of one which is
removed.
• Install - Place a component or assembly in the correct position.
S t a r
Pattern Torque Sequence