Table of Contents
Advertisement
Fuel System
DODGE Turbo Diesel
Fuel System Replacement Procedures
Page 14-29
Bar the engine until the key way on the fuel pump shaft is in the
approximate position shown.
Caution: Be sure to disengage the pin after locating TDC.
Locate TDC for Cylinder Number 1 by barring engine slowly
while pushing in on TDC pin. Stop barring the engine as soon
as pin engages with the gear timing hole.
Note; Check the timing marks on the flange of the injection
f ^ T j
pump. Each pump and engine have unique marks. It is not
v l /
possible to exchange pumps and use the same marks for
alignment.
10mm Hex
Loosen the lockscrew and remove the special washer from
injection pump. Tighten the lockscrew against the drive shaft.
Tighten the lockscrew.
Torque Value: 30 N-m [22 ft-lbs]
Note: Wire the special washer to the pump so it can be re-
installed later.
75mm T-Bar
Pull the pump drive gear from the drive shaft.
Note: Puller capscrew size is M8-1.25.
Advertisement
Table of Contents
Troubleshooting
