Quick‐Start
Installing 400/480 Volt Melters
E 2014 Nordson Corporation
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
If you have already installed the melter using the installation guide
(P/N 1024498) that is provided inside the shipping container, and you have
no questions concerning the installation, go to Setting Up the Melter later in
this section for information about how to prepare the melter to operate with
your manufacturing process.
Refer to Appendix E for information about installing 400/480 volt ProBlue
adhesive melters. After completing the procedures described in Appendix E,
you will be referred back to this section to set up the melter.
Installation
Section 3
Installation
Part 1024496_06
3-1