More About Heated Components - Nordson ProBlue P4 Customer Product Manual

4-2
Operation

More About Heated Components

Component keys
(tank, hose, and gun)
Part 1024496_06
The melter contains three groups of heated components. These are the tank
group, which contains the tank and the manifold, the hose group, and the gun
group. Component groups are represented on the control panel by the
component keys shown to the left.
Heated components within each group are identified by their position
number. The position of the tank and pump is fixed at 1. Hose and gun
position numbers are automatically assigned based on the hose/gun
receptacle they are connected to. For example, the position numbers of a
hose/gun pair that is connected to the second receptacle would be hose
position 2 and gun position 2.
The number of hose/gun receptacles available on each melter depends on
the configuration in which the melter was ordered. ProBlue adhesive melters
may have either two, four, or six hose/gun receptacles. An optional
expansion base may be ordered that adds receptacles for two additional
hoses/guns.
E 2014 Nordson Corporation