Nordson ProBlue P4 Customer Product Manual page 18

1-8
Safety
General Safety Warnings and Cautions
Equipment
Type
HM
HM, PC
HM, CA, PC
HM, CA, PC
Table 1‐1 General Safety Warnings and Cautions (contd)
WARNING! Molten material! Wear eye or face protection, clothing that
protects exposed skin, and heat‐protective gloves when servicing
equipment that contains molten hot melt. Even when solidified, hot melt
can still cause burns. Failure to wear appropriate personal protective
equipment can result in personal injury.
WARNING! Equipment starts automatically! Remote triggering devices
are used to control automatic hot melt applicators. Before working on
or near an operating applicator, disable the applicator's triggering
device and remove the air supply to the applicator's solenoid valve(s).
Failure to disable the applicator's triggering device and remove the
supply of air to the solenoid valve(s) can result in personal injury.
WARNING! Risk of electrocution! Even when switched off and
electrically isolated at the disconnect switch or circuit breaker, the
equipment may still be connected to energized auxiliary devices.
De‐energize and electrically isolate all auxiliary devices before
servicing the equipment. Failure to properly isolate electrical power to
auxiliary equipment before servicing the equipment can result in
personal injury, including death.
WARNING! Risk of fire or explosion! Nordson adhesive equipment is
not rated for use in explosive environments and has not been cerfified
for the ATEX directive or as nonincendive. In addition, this equipment
should not be used with solvent‐based adhesives that can create an
explosive atmosphere when processed. Refer to the MSDS for the
adhesive to determine its processing characteristics and limitations.
The use of incompatible solvent‐based adhesives or the improper
processing of solvent‐based adhesives can result in personal injury,
including death.
Issued 10−11
(contd)
Warning or Caution
Continued...
E 2014 Nordson Corporation