Melter Communications; Software Availability; System Requirements - Nordson ProBlue P4 Customer Product Manual

Software Availability

System Requirements

E 2014 Nordson Corporation

Melter Communications

This appendix describes the installation and use of the Nordson
Configuration Manager (NCM) communications utility. With this utility you
can:
S
transfer operating parameters and temperature set‐points between
melters
S
upgrade or reload your melter's firmware
If you do not already have the NCM utility, you can download it from the
internet by navigating to www.enordson.com/support.
If you do not have a connection to the internet, you can request a software
CD from your Nordson representative.
The following hardware and software requirements are necessary to install
and run Blue Series software:
S
Any ProBlue adhesive melter or a DuraBlue 10/16 adhesive melter
S
Serial cable
S
Personal computer with:
S
CD‐RW drive or 3.5‐inch floppy drive
S
Available COM port
S
640 x 480 color monitor
S
Windows 95, 98 (second edition), ME, XP, or 2000
S
Internet Explorer version 4.0 or later (IE 5.0 is recommended)
S
Administrative privileges (Windows XP, 2000, and NT)
Melter Communications
Appendix
Part 1024496_06
C-1
C