Nordson ProBlue P4 Customer Product Manual page 60

3-30
Installation
Operating Parameters
Part 1024496_06
(contd)
You can exit the setup mode at any time by
pressing the Setup key.
Parameter numbers that are not applicable
are skipped when you scroll through the
operating parameter list in the left display.
When the right display is flashing, you can
quickly set the value of the current
parameter to it's lowest possible value by
simultaneously pressing both of the
right‐display scroll keys.
While in the setup mode, if no key is
pressed for two minutes, the melter will
return to the automatic scan mode.
You can also use the right‐display scroll
keys to enter or change a parameter's value
or control option. After entering the
parameter's number in the left display,
press either of the right‐display scroll keys
to change the value or control option.
If password protection is enabled, the
melter will return to the password protected
mode whenever you exit the setup mode.
Appendix B, Parameter 10
E 2014 Nordson Corporation