To Read Or Edit A Parameter - Nordson ProBlue P4 Customer Product Manual

Melter control switch (On/Off)
Setup key
Clear/Reset key
Enter key
E 2014 Nordson Corporation

To read or edit a parameter

1. Switch the melter on.
The melter performs a start‐up check.
2. Press the Setup key.
The left display flashes parameter 1.
3. Use the numeric keypad to enter the number of the desired parameter.
Refer to Table 3‐6 for a complete list of parameters.
NOTE: If you incorrectly enter the parameter number, press the
Clear/Reset key to return to parameter 1 and then re‐enter the correct
parameter number.
When you have finished entering the one‐ or two‐digit parameter number,
the right display indicates the parameter's current value.
4. Do one of the following:
S
If the value is noneditable, refer to Section 4, Monitoring the Melter.
S
If the value is editable go to step 5.
5. Press the Enter key.
The right display flashes.
6. Use the keypad to enter the desired numeric set‐point or control option
into the right display. Refer to Appendix B for information about the
numeric value or control option choices for each parameter.
NOTE: If the keypad has no affect on the right display, the melter is
password protected. You must enter a valid password before you can
edit parameters. Refer to Section 4, Entering the Melter Password.
7. Press the Enter key.
The melter checks that the new value or control option is acceptable.
S
If the numeric set‐point or control option is accepted, the left and right
displays index to the next sequential parameter number and value.
S
If the numeric set‐point or control option is not accepted, the right
display will indicate dashes (‐‐‐‐) for three seconds and then it will
change back to the original value.
8. Repeat step 5 through step 7 to read or change the next sequential
parameter number or press the Setup key to exit the setup mode.
3-27
Installation
Part 1024496_06