4-18
Operation
Monitor the Service Interval
Service LED (yellow)
Clear/Reset key
Part 1024496_06
The melter can be set up so that the service LED located on the left side
of the control panel turns on after a customer‐defined time period elapses.
The service LED may be used to signal the need to change the hot melt filter
or to complete any other customer‐specified maintenance activity. Once the
specified maintenance is performed, the service LED must be reset.
To reset the service LED
With the melter in the scan mode, press the Clear/Reset key to turn off the
service LED and reset the service interval time.
The default setting for the service
interval time is 500 hours.
Appendix B, Parameter 5
E 2014 Nordson Corporation