Connect The Transformer To The Melter - Nordson ProBlue P4 Customer Product Manual

E-16
400/480 Volt ProBlue Adhesive Melters

Connect the Transformer to the Melter

Part 1024496_06
1. Route the three wire harnesses from the transformer up into the melter's
electrical enclosure.
See Figure E‐9.
2. Connect the power harness to terminal J1 on the melter main board.
3. Connect the control harness to terminal J9 on the melter main board.
4. Connect the heater power harness from the transformer to the heater
power harness plug that enters the bottom of the melter's electrical
enclosure.
See Figure E‐10.
5. Use the conduit plate, M5 screws, and washers provided in the
installation kit to cover the service entrance on both the transformer and
the melter.
6. Refer to the ProBlue adhesive melter product manual, Section 3,
Installation, Setting Up the Melter.
E 2014 Nordson Corporation