Table of Contents
Advertisement
Using the Monitor Program
Accessing the Monitor Program
To access the Monitor program:
1. The Monitor program uses the fixed IP address 192.168.254.251.
with the subnet mask 255.255.255.0. The PC used for accessing the
Monitor program should be configured accordingly. It is
recommended to set the PC's IP address to 192.168.254.250, which
is the default TFTP Server IP address (required for downloading SW
versions and for downloading/uploading configuration files.
NOTE
The IP address 192.168.254.251 is used only for the Monitor program. This is not the IP
address used by the unit other purposes. The IP parameters for management purposes
are allocated by the NPU during the Network Entry process.
2. Connect the PC to the Ethernet port, using a straight cable.
3. Run the Telnet program connecting to 192.168.254.251. The Enter
the passwod prompt is displayed. Enter the password and press the
Enter key.
NOTE
Following three consecutive failures to enter the correct password, access to the
Monitor program will be blocked for 5 minutes.
The factory default password is "installer".
If you forgot the password, type "help" to get a challenge string consists of 24
characters. Contact Alvarion's Customer Service and give them the challenge string
(after user identification) to receive a one-time password. You can use this password
only for one time entrance to the program. The password must be changed during the
session to a different "permanent" password. The administrator should be notified of
this new password. Five consecutive errors in entering the one-time password will
invalidate it, and a new challenge string should be used to get an updated one-time
password.
4. The Main menu of the SU Installer Monitor program is displayed,
enabling you to access the required parameters configuration and
performance monitoring options.
Manual Revision 1.0
Using the Monitor Program
B-3
Advertisement
Table of Contents
