Table of Contents
Advertisement
Chapter 4 - Operation and Administration
Show
The Show option enables viewing the current status of the following
parameters:
Uplink RSSI (dBm)
Uplink SNR (dB)
Uplink Rate
Downlink RSSI (dBm)
Downlink SNR (dB)
Downlink Rate
ATPC Support
Tx Power (dBm)
Set Rates
The Set Rates option is available only when the Multirate algorithm is
disabled in the AU (see
set the Uplink Current Rate and the Downlink Current Rate to any of
the values listed in Table 4-3 on page 4-41.
The defaults are the last rates used by the Multirate algorithm before it
was disabled. For SUs that join the cell when the Multirate algorithm is
disabled, the defaults are the applicable Basic Rates.
4-58
Multirate Parameters
on page 4-40), allowing to
BreezeMAX System Manual
Advertisement
Table of Contents
