Table of Contents
Advertisement
Chapter 4 - Operation and Administration
Unit Control
The AU Unit Control menu enables resetting the AU and managing the
SW versions of the module.
The Unit Control menu includes the following options:
Reset
Set Factory Defaults
SW Version Control
Reset Unit
Select this option to reset the unit. To avoid unintentional reset, you
will be prompted to confirm the reset request. Changes to some of the
configurable parameters are applied only after reset. Refer to
NPU/Micro Base Station Parameters Summary
information on which parameters are changeable in run time and which
changes are applied only after reset.
Set Factory Defaults
Select this option to set the AU parameters to their factory default
values. Refer to
4-83 for information on the factory default values of these parameters.
The parameters will revert to their default values after the next reset.
SW Versions Control
The AU can contain two SW versions:
Main: Each time the AU resets it will reboot using the version
defined as Main.
Shadow: Normally the Shadow version is the backup version. Each
time a new SW File is downloaded to the AU, it will be stored as a
Shadow version, replacing the previous Shadow Version.
The process of upgrading to a new SW version is controlled by the NPU,
and is performed using one of the AU SW files installed in the NPU. If
the specified AU SW file does not exist in the AU, it will be downloaded
to the AU and the requested operation will be executed, as described
below. If it already exists in the AU, then actual loading is not
necessary.
The following options are available in the SW Version Control menu:
4-34
NPU/Micro Base Station Parameters Summary
on page 4-83 for
on page
BreezeMAX System Manual
Advertisement
Table of Contents
