Table of Contents
Advertisement
Chapter 2 - Installation
Ejecting Modules
To eject an NPU or AU-IDU module:
1. Release the screws at the top and the bottom of the front panel.
2. Press the handles' red button until the handles are unlocked.
3. Wait until the blue HOT SWAP LED turns on, indicationg that the
module has been disconnected and can be removed.
4. Press the handles down (the upper handle)/up (the lower handle)
until the module is unlocked, firmly hold the handles and take the
module out of the chassis.
To eject a PIU or PSU module:
1. Release the screw at the top of the front panel.
2. Press the handle's red button until the handle is unlocked.
3. Press the handle up until the module is unlocked, firmly hold the
handle and and take the module out of the chassis.
CAUTION
Disconnect power from the PIU module before inserting/ejecting it to/from the chassis.
Before disconnecting the power cable from the PIU, the power source must be
disconnected to avoid irreversible damage due to a potential excessively high transient
current.
2-26
BreezeMAX System Manual
Advertisement
Table of Contents
